GOCONTROL Z-Wave Smart Glass Break Sensor & Detector (Batteries NOT included) - 2 PACK - 0GB00Z-2
Batteries NOT included
The GoControl Z-Wave Glass Break Detector is a smart, Z-Wave-enabled glass break sensor that is battery powered. It is ideal for use in properties where vulnerable glass areas are at risk of being broken to gain access to property or premises.
The GoControl Glass Break Sensor (GB00Z-2) offers superior monitoring of glass windows or doors and alerts the homeowner when a break has been detected. Unlike other ‘shock’ - type detectors, which can only be affixed to one single pane of glass, the GoControl Glass Break Sensor can be easily mounted on the wall or ceiling and monitor multiple windows or glass doors within a 12-foot radius of the sensor. Advanced two-stage "thump & crash" detection technology uses acoustic monitoring and analysis to significantly reduce false alarms. The GoControl Glass Break Sensor effortlessly integrates with any Z-Wave hub, app, and other devices to alert homeowners when a glass break event has occurred.
- Always ready detection
- Spatial detection of window shattering sounds
- Long-life battery included
- Z-wave communications test button
This Z-Wave Glass Break Sensors used an alarm panel so you can get updates directly to your phone. This keeps your glass windows and doors fully covered. Plus, you can monitor multiple windows, doors and ceilings with this sensor. If any glass is broken, you can find out immediately.
Operating Temperature: 32° to 120° F (0° to 49° C)
Operating Relative Humidity: 5 to 95%, non-condensing
Operating Frequency: 908.42 MHz
Battery Type: Two 3-Volt CR123A Lithium Batteries
Sensor Type: Single microphone,
dual-stage (thud & crash)
The minimum size for all glass types is 11” x 11” (28 cm x 28 cm) square. Glass must be framed, in a wall of the room or mounted in a barrier of 36” (91 cm) minimum width.
Glass type Minimum to Maximum thickness
Plate 1/8” to 1/4” (3.2 mm to 6.4 mm)
Tempered 1/8” to 1/4” (3.2 mm to 6.4 mm)
Sealed, Insulating 1/8” to 1/4” (3.2 mm to 6.4 mm)
NOTE: Device may be packaged for Utilitech/Lowes (Iris) but device will work with most Z-Wave controllers.